Honda BF100D, Руководство пользователя

Страница: 86 / 155

84
SERVICING YOUR OUTBOARD MOTOR
4. Clean the oil filter mounting base,
and coat the rubber seal of the new
oil filter with clean engine oil.
Use only a Honda Genuine oil filter
or a filter of equivalent quality
specified for your model.

Using the wrong filter, or a non-
Honda filter which is not of
equivalent quality, may cause engine
damage.
5. Screw on the new filter by hand
until it contacts the engine, then use
a suitable tool to tighten the filter
an additional 7/8 turn.
OIL FILTER TIGHTENING
TORQUE:

9 lbf·ft (12 N·m, 1.2 kgf·m)
6. Return the outboard motor to the
vertical position, and fill the
crankcase with the specified
amount of the recommended oil.
7. Start the engine and check for leaks
(be sure the water level is at least 2
inches (5 cm) above the
antiventilation plate).
If you are changing the oil filter
while the outboard motor is out of
the water, use commercially
available ear muffs and water hose
to supply water.
Running the outboard motor
without sufficient cooling water
will damage the water pump and
overheat the engine.
8. Stop the engine, and check the oil
level as described on page 80. If

necessary, add oil to bring the oil
level to the upper limit mark on the
dipstick.
Engine Oil Recommendations
Oil is a major factor affecting
performance and service life. Use

4-stroke detergent oil.
Honda 10W-30 FC-W
®
outboard
motor oil is recommended for general
use.
FC-W
®
is a registered trademark of
the National Marine Manufacturers
Association.
If Honda 10W-30 FC-W oil is not
available, Honda recommends that
you use API service category SG, SH
or SJ oil. The SAE oil viscosity and
service category are in the API label
on the oil container.
SAE Viscosity Grade
AMBIENT TEMPERATURE
31ZY96300.book 84 ページ ２０１３年１０月２１日 月曜日 午前９時２５分