Open the bonnet.
Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
Push the electrical connector onto
the tabs of the new bulb. Make
sure it locks in place.
Turn on the headlights to test the
new bulb.
Remove the rubber weather seal
by pulling it.
Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way, and remove the bulb.
Remove the electrical connector
from the bulb by pulling the
connector straight off.
Install the rubber weather seal
over the back of the headlight
assembly. Make sure it is right
side up.
1.
2.
3.
4.
5.
6.
7.
Lights
Maintenance
259
BULB
HOLD-DOWN WIRE
WEATHER SEAL
CONNECTOR
06/10/30 17:17:19 32SJD620_262
Содержание automobile
