Honda activa 2009, Руководство пользователя, Страница: 62 / 85

54
If a torque wrench is not used for this
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Change the engine oil from the engine at
normal operating temperature and the
scooter on its center stand to assure
complete and rapid draining.
1.
Start the engine and let it idle for 3-5
minutes.
2. Stop the engine. Turn the ignition off and
to be on safer side remove the ignition
key from ignition switch.
3. Place an oil drain pan under the crankcase.
Remove the oil filler cap/dipstick, oil drain
bolt (1) and sealing washer (2).
4. After the engine oil has been drained out
hold the scooter upright for 10-15 seconds
to assure complete draining.
5. Operate the kickstarter several times to
aid in complete draining of the remaining
oil.
6. Check that the sealing washer (2) on the
drain bolt is in good condition and install
the bolt. Replace the sealing washer every
other time the oil is changed, or each time
if necessary.
Oil Drain Bolt Torque:
24 N.m (2.5 kgf.m, 18 Ibf.ft)
7. Fill the crankcase with recommended
grade oil;
0.7L (0.7 US qt, 0.6 Imp qt)
8. Reinstall the oil filler cap/dipstick.
9. Start the engine and let it idle for 3-5
minutes.
10. Stop the engine and wait 2-3 minutes.
Check that the oil level is at the upper
level mark on the dipstick with the scooter
upright on firm, level ground.
Make sure there are no oil leaks.
(1) Oil drain bolt ¼vkW;y Mªsu cksYV½
(2) Sealing washer ¼lhfyax ok”kj½
(2)
(1)