2
www.homewerksww.com
PRODUCT SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
Min. Flow Rate: 2.4 GPM (9.0 LPM) at 20 PSI
Polished chrome, brushed nickel or brushed bronze finish
ASME A112.18.1/CSA B125
Ceramic cartridges
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
1
5.
Remove the index (1 & 2),
loosen the screws (3) and
remove the handles (4). Loosen
the flanges (5) from the valve
bodys (6 & 7). Adjust the rubber
washers (8), metal washers (9)
and mounting nuts (10) to the
bottom of valve bodys (6 & 7).
2
1
3
3
4
4
5
5
6
7
8
9
10
8
9
10
5
2. Drill holes in the finished deck as
shown in the diagram below.
NOTE:
This kit allows up to
1-7/8 in. deck thickness.
5 in.
min.
8~1
6 in.
3 in
. m
in.
1-7/8
in. M
AX. D
ECK
TH
ICK
NES
S
1-3/8 in.
Diamter
1-3/8 in.
Diamter
1-1/8 in.
Diamter
2
6.
From underneath the deck,
insert the cold end valve (1) with
the rubber washer (2), metal
washer (3) and mounting nut (4)
through the hole on the right
(cold) side. From above, thread
the flange (5) onto the valve
body (1). Tighten the mounting
nut (4) using a basin wrench, so
that the flange (5) sits flush
against the finished deck
surface. Repeat this procedure
for the hot end valve (6) on the
left (hot) side.
NOTE:
The hot end valve is
identified with a label.
5
1
2
3
4
6
6
3. Remove the clip (6) and T-tube
(5) from the spout assembly (1).
Loosen the mounting nut (4) and
remove the washers (2 & 3) from
the spout assembly (1).
1
2
3
4
5
6
3
7.
Place the handle (3) onto the
cartridge stem (4). Place the
screw (2) into handle (3) and
tighten screw (2). Place the
other handle onto the left (hot)
valve and install the same way.
3
2
1
4
7
4.
Installing the Spout Assembly:
Insert the spout assembly through
the hole in the deck. Secure the
spout assembly with the rubber
washer (1), metal washer (2) and
mounting nut (3).
1
2
3
4
8.
Installing the T-tube:
From below the deck, push the
T-tube (1) onto the spout shank
(A) until it is completely seated.
Place the clip (2) through the
slots (B).
A
B
1
2
8
