38
Start-up
Permitted cable cross sections for connecting to the
blind actuator are:
rigid cable [mm
2
]
flexible cable
without ferrule [mm
2
]
0.75 – 2.50
0.75 – 2.50
5.2
Selecting the supply voltage
Voltage supply of the blind actuator is established only
via the Homematic IP Wired bus. The bus is supplied by
the Homematic IP Wired Access Point (HmIPW-DRAP)
(please refer to the user manual of the HmIPW-DRAP).
The maximum total current consumption of the blind ac-
tuator is as follows:
I
ges
= 100 mA
5.3
Mounting and installation
Please read this entire section before starting to
install the device.
To install the blind actuator on a DIN rail within a distribu-
tion board, please proceed as follows:
• Disconnect the power distribution panel and
cover any live parts, if required (see hazard infor-
mation).
• Remove the cover of the power distribution
panel.
