54
55
device is being operated in conjunction with a Home-
Matic central control unit, a service message is sent to
the CCU too.
Never recharge standard batteries. Do not throw
the batteries into a fire. Do not expose batteries
to excessive heat. Do not short-circuit batteries.
Doing so will present a risk of explosion.
Used batteries should not be disposed of
with regular domestic waste. Instead,
take them to your local battery disposal
point.
8.2. Teaching-in
Please read this section completely before star-
ting with any teaching!
In order to enable communication between radio
components, the devices have to be taught-in to one
another. If you want to use the display push-button to
switch HomeMatic actuators, proceed as follows:
• Open the configuration menu by
pressing and holding down the button
on the left or right (<>) for more than
4 seconds.
•
The top menu level appears on the display. Press
the button on the left/right (<>) to browse through the
different items in that menu level.
•
Select the “teach-in” item menu by pressing the but-
ton at the bottom (˅) .
•
In the next menu level you can
select a storage position (channel)
by pressing the button on the left/
right (<>). The next available positi-
on is displayed for selection first.
• Confirm your selection by pressing
the button at the bottom (˅).
In order to teach in at a central control unit, se-
lect the “Central control unit” entry (press but-
ton <).
•
You can now activate the teach-in
procedure by pressing the button at
the bottom (v).
For the next 20 seconds the display
push-button will search for another
HomeMatic component that is also in
teach-in mode.