8
G
B
USING YOUR ULTRASLIM PRO
UltraSlim Pro Control Panel and Functions
Treatment zone Indicators
Timer Display
(minutes)
Intensity Display
(Level)
Increase or decrease
treatment time
Increase or decrease
intensity level
Start/Pause
treatment
MODE: Select preset
treatment zone
Beginning a treatment session
Once you have plugged the machine into the mains supply and turned on the power switch (reverse of unit),
the following default settings will appear on the monitor:
Treatment Zone: Abdomen Time: 15 minutes Intensity: Level 4
To scroll through the different treatment zone press
. The LED for the selected zone will illuminate.
N.B.
The treatment zone cannot be changed once treatment starts.
With the required Treatment Zone, Level and Time selected you are ready to begin. First ensure sufficient gel
has been applied to the treatment area, remove the Ultrasound applicator from the bracket and press
to
start treatment
With the metal surface of the Ultrasound applicator, massage the area using the techniques shown on the
next page.
To pause treatment press
and simply press again to restart the treatment .
If the session is not restarted within 5 minutes the device will emit a beep and enter standby mode. To
reactivate press
to recall the session and
to continue treatment.
Once the timer reaches zero, the treatment will stop and the unit will emit a double beep.
Customising your treatments
The preset time and intensity levels take into account the amount and depth of fat normally located in the
specific treatment areas and are therefore recommended for normal use.
The table below provides guidelines for the pre-set treatment times/levels.
Treatment area
Pre-set time
Power level
Abdomen/lower back
Thighs/Legs
Buttocks
Upper arm
15 mins
10 mins
12 mins
8 mins
4
3
4
3
IB-USL1000EU-0413-02_Layout 1 02/05/2013 17:02 Page 8
