60
61
EN
EN
The hair remover starts making a humming noise. The light on indicator
symbol 1 is constantly lit green and indicates that the hair remover is running
on energy setting 1. Shortly after, the light on the indicator symbol begins
to light up orange.
3. If necessary, press the operating button several times to change the energy
setting. The light of the selected energy setting and all energy settings
below this are permanently lit green.
The type of use differs depending on the energy setting selected:
• Gliding method when a low energy setting is selected.
• Pulsating method when a high energy setting is selected.
4. Use in compliance with the respective method and according to the
energy setting, as described in the following.
Usage with gliding method
If the light pulse is not released by pressing the pulse trigger and the
light on the indicator symbol starts flashing quickly, then the skin
colour sensor has reacted because the area of skin is too dark for
safe use.
1. Place the treatment area
6
fully onto the area of skin to be treated and
test with a constant, gentle pressure.
The indicator symbol starts to flash slowly on the operating button
4
.
2. Keep pressing the pulse trigger
7
and move the hair remover slowly
and carefully over the entire area of skin to be treated. The treatment
area must always remain in contact with the skin during the process.
With a slight delay the hair remover starts to release continuous light
pulses. For low energy settings the hair remover needs around 1–1.5
seconds between each light pulse to reload and release again.
Usage with pulsating method
If the light pulse is not released by pressing the pulse trigger and the
light on the indicator symbol starts flashing quickly, then the skin
colour sensor has reacted because the area of skin is too dark for
safe use.
1. Place the treatment area
6
fully onto the area of skin to be treated and
test with a constant, gentle pressure.
The indicator symbol starts to flash slowly on the operating button
4
.
2. Press the pulse trigger
7
.
With a slight delay, a light pulse is released. After the light pulse is released,
the light on the indicator symbol goes out.
3. Place the treatment area on the area of skin to be treated next.
The indicator symbol starts to flash again slowly and signals that the hair
remover is ready to release the next light pulse.
