Operation
16
PAIRING PROCESS
Select desired frequency from the back of transmitter.
Press the transmitter’s “ ” button, and hold the “ ” button for over 5 seconds. Once the receiver has detected the frequency, the
fan will automatically begin to operate and start to run for 10 seconds. If a light kit is installed, the light will blink two times.
NOTE:
The pairing function will only mandate within 60 seconds when turning the fan’s AC power ON.
M
REMOTE CONTROL OPERATING INSTRUCTIONS
1
2
3
4
5
6
Remote Control only: Install an A23 12 volt battery (included). To
prevent damage to transmitter remove the battery if not used for
long periods of time.
Your DC brushless motor is equipped with a self learning frequency
function remote control. Restore power to the ceiling fan and test
the transmitter as below for proper operation:
A. 1, 2, 3, 4, 5 and 6 button:
These six buttons are used to set the fan speed as follows:
1 = minimum speed
2 = low speed
3 = medium low speed
4 = medium speed
5 = medium high speed
6 = high speed
B. Reverse Button:
This button is used to change the direction of the rotation of the blades; counterclockwise for summer weather or clockwise for winter
weather.
C.
Button:
This button turns the power Off to the Fan.
D.
Button:
Fans that feature an UP light ( button) and a DOWN light ( button) that are controlled independent of each other. Press and release
the button for the desired light to turn the light ON or OFF. Press and hold the button to set the desired light brightness. The light will
cycle between bright and dim settings as long as the button is pressed. The light key has an automatic auto-resume feature that allows
the light to remain at the same brightness as the last time it was turned off.
NOTE:
On each start up of your ceiling fan, the fan blades
will oscillate back and forth. This is a NORMAL OPERATION
for DC motor ceiling fans as they go through a calibration
cycle. The fan is NOT DEFECTIVE.
