WARNING:
Failure to properly install the cotter pin (GG)
could result in the fan loosening and possibly falling.
Carefully feed the motor wires up through the downrod
(NN). Thread the downrod (NN) into the collar.
Align the holes and replace clevis pin (HH) and cotter pin
(GG). Tighten the two collar setscrews (II).
Slip the coupling cover (E), canopy ring (B), and canopy (C)
onto the downrod (NN).
Carefully reinstall the hanger ball (KK) onto the downrod
(NN) and reinstall the ground lead (MM) onto the downrod
(NN), being sure that the cross pin (LL) is in the correct
position, the setscrew (JJ) is tightened and wires are not
twisted.
NOTE:
If a longer downrod (not included) is needed, take out
the screw located in the hanger ball (KK), lower the hanger
ball (KK) and remove the pin (LL). Remove all three pieces
from the downrod and assemble them onto the new longer
downrod before proceeding to the downrod installation.
Assembly
1
Preparing the canopy
Preparing the motor
2
Remove the cotter pin (GG) and clevis pin (HH), and loosen
the two collar setscrews (II) from the motor collar.
Take out the setscrew (JJ) located in the hanger ball (KK),
lower the hanger ball (KK) and remove the cross pin (LL).
Remove the hanger ball (KK) from the hanger ball/downrod
assembly (D).
Remove the ground lead (MM) from the downrod assembly (D).
Remove the canopy ring (B) from the canopy (C).
Remove the two non-slotted canopy mounting screws (FF)
from the canopy (C), and loosen the slotted canopy
mounting screws (FF) on the canopy (C).
Remove the canopy (C) from the mounting bracket (A) by
turning the canopy (C) counterclockwise.
3
Assembling the fan
8
II
II
HH
GG
Tools Required:
Phillips
screwdriver
B
F
E
NN
C
II
II
HH
GG
LL
JJ
MM
JJ
D
LL
KK
MM
KK
A
FF
FF
C
B
