15
Assembly — Hanging the Fan (continued)
12
Attaching the LED light kit
and glass shade
CAUTION:
Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
Remove one of the three light kit mounting screws (QQ)
from the light kit mounting plate (J) and loosen the other
two screws (QQ). (Do not remove.)
While holding the 20W LED light kit (K) under the fan motor
assembly (F), make the 2-pin wire connections:
- White to white
- Blue to black
Place the key holes in the 20W LED light kit (K) over the two
mounting screws (QQ) previously loosened from the light kit
mounting plate (J). Turn the LED light kit (K) until the LED
light kit (K) locks in place at the narrow section of the key
holes. Secure by tightening the two light kit mounting
screws (QQ) previously loosened and the one (QQ)
previously removed.
Position the notches (RR) in the outer rim of the glass
shade (L) so they line up with the tabs (SS) on the
inside of the rim on the 20W LED light kit (K).
Carefully lift the glass (L) up inside the 20W LED light
kit (K) and secure it to the fan by turning the glass
shade (L) clockwise until snug. DO NOT OVERTIGHTEN.
Please contact 1-800-986-3460 for further assistance.
HOMEDEPOT.COM/HOMEDECORATORS
F
RR
K
L
J
SS
Tools Required:
Phillips
screwdriver
Ladder
