- 2 -
ASSEMBLY
* We recommend that TWO PEOPLE work together on the assembly,
due to the weight of this cart. Cart weight is approximately 170 lbs,
please be careful during assembly.
1. Locate the key tied to the bottom tray. Using the key, open the slide-
top lid and remove the caster box from the bottom drawer. After removal,
make sure all drawers are completely closed and the inside lever is in the
locked position. Close and lock the slide-top lid.
2. Using the protective foam provided, lay out a work surface. Gently turn
the cart upside down so the slide-top is on the foam surface.
3. (Before assembling the legs remove the cable
tie holding the bumper in place). Insert the front
leg (Part E), labeled FL or FR into top lip of the
cart. Then place the Front bumper (Part F) over
the leg aligning the center bolt holes. With holes
aligned insert stove bolt (Part G) and fi nger tighten
with washer, spring washer and then the nut.
4. Install back leg (Part E) labeled BL or BR and
bumper (Part F) following the same procedure as
above. Note: Make sure the back leg is inside the
hinge rivet. Otherwise the holes will not line up
during assembly.
5. Repeat steps 3 & 4 to mount the legs on the
opposite side.
6. Completely tighten the 8 bolts just inserted.
7. Insert bottom shelf (Part H) between the four
legs fl at side facing up towards the ceiling (be-
cause cart is assembled upside down).
Insert sixteen stove bolts, washers, spring wash-
ers and nuts (Part G) and completely tighten.
8. Mounting casters: Put the four casters in place.
The two locking casters should be on one side of
the cart and the two non locking casters should be
on the other (Left or right side NOT front or back).
Step 4
Step 6
Step 7
