20 | EngliSH
4. Packaging, Transport and Storage
4.1. Delivery
After receipt, the shipment must be checked for damage
and completeness immediately. In the event of any de-
ficiencies, the transport company and the manufacturer
must be informed on the day of receipt, as no claims can
otherwise be made or considered valid. Any damage must
be noted on the delivery or transport receipt.
4.2. Transport
Do not throw or tip the lifting unit during transport.
Make sure that the lifting unit does not come into con-
tact with sharp edges. Protect the lifting unit from heavy
blows. The products are shipped in suitable packaging
by the manufacturer or supplier. This generally excludes
damage during transport and storage. Should you change
locations frequently, save the packaging carefully for re-
use.
4.3. Storage
Newly delivered products are prepared for up to 1 year of
storage. If the product is being placed in interim storage, it
must be thoroughly cleaned before being stored!
The following must be observed for storage:
•
Place product securely on a fixed base and secure
against tipping over.
•
In addition, ensure that the equipment is stored in
dry areas.
•
Products with vacuum and/or pressure connections
must have these tightly closed to prevent contami-
nation.
•
During extended storage the shaft must be protected
against moisture, sunlight, heat and frost.
If you observe these regulations, your product can be
stored for a longer period of time. However, note that the
elastomer parts and coatings are subject to natural em-
brittlement.
4.4. Materials returned
Products that are returned to the factory must be clean
and correctly packaged. „Clean“ means that the product
has been cleaned of contaminations and that it has been
contaminated in the event of use with mediums that are
hazardous to health. The packaging must protect the prod-
uct from damage. Please contact the manufacturer before
returning the product.
5. Installation and initial operation
5.1. General
To avoid damage to the lifting unit during installation and
during operation, the following points must be observed:
•
The installation work must be performed by qualified
personnel in compliance with safety regulations.
•
The lifting unit must be inspected for possible dam-
age prior to installation.
•
For level controls, pay attention to the minimum wa-
ter coverage.
•
Protect the pump from frost.
•
The power lines of the pump must be laid in such a
way, that a safe operation and easy assembly/disas-
sembly is ensured.
5.2. Installation
It is up to the operator to prevent consequential dam-
ages, for example by flooding of rooms during distur-
bances at the pump, by means of appropriate mea-
sures (e.g. installation of an alarm system, a reserve
pump or similar).
The lifting unit must be installed in a manner that al-
lows the lid to be opened. Ensure that there is suffi-
cient free space between the side inlets and existing
walls.
According to the standard, drainage facilities which
have drain trap, the lowest point of which is over 180
mm from the lower edge of the lifting system, must be
connected to the system by means of a suitable pipe
loop (see installation example).
Содержание San.iQ cut V
Страница 50: ...50 Notizen Notes...