Holzstar FKS 315-1500 E, Инструкция по эксплуатации, Страница: 14 / 28

14 FKS 315-1500 E | Version 1.07
Care, Maintenance and Repair
Fig. 26: Unscrew the saw blade
Step 6: Remove the saw blade flange and the saw blade.
Step 7: Place the new saw blade with flange and nut on
the shaft and tighten the nut (counterclockwise).
Step 8: Check that a correctly dimensioned cutting knife
and a suitable auxiliary saw blade are fitted and
aligned with the saw blade.
Step 9: Mount the saw blade guard.
9.2.2 Change of the riving knife
Fig. 27: Adjust the Riving knife
Step 1: Disconnect the power plug from the power outlet.
Step 2: Adjust the saw blade inclination angle to 0 ° (90 °
to the saw table) and raise the saw blade as far
as possible.
Step 3: Push the sliding carriage to the right as far as
possible, unscrew the two M6x12 screws and re
-
move the saw blade guard.
Step 4: Loosen the fastening bolt for the separating knife
and remove the cutting knife.
Step 5: Insert the new cutting knife and loosely screw it
on.
Fig. 28: Set the distance of the cutting blade to the saw blade
Step 6: Screw the cutting knife with a distance between 3
mm and 8 mm from the saw blade.
Step 7: Attach the saw blade guard.
9.2.3 Replace the drive belt
Step 1: Disconnect the power plug from the power outlet.
Step 2: Remove the saw blade, s. Section "saw blade
change".
Step 3: Remove the chip container by unscrewing the 3
M8x18 screws.
Fig. 29: Replace the drive belt
Step 4: Unscrew the 4 screws of the left cover and re
-
move the cover.
DANGER!
If the saw blade thickness has changed, an appropri-
ately dimensioned cutting knife and a suitable auxili-
ary saw blade must now be mounted.
DANGER!
The riving knife is partially structured. The structured
area must be below the saw table.
The mounting bolt is inserted in a slot so that the
horizontal distance to the saw blade can be varied.
NOTE!
When removing the lower two M8x18 screws, the in
-
clination angle is tilted to 30 °, when removing the up
-
per M8x18 screw, the inclination angle is tilted to 0 °.