Holzstar FKS 315-1500 E, Инструкция по эксплуатации, Страница: 12 / 28

12 FKS 315-1500 E | Version 1.07
Care, Maintenance and Repair
8.2 Sawing with the sliding table
Step 1: Slide the sliding table out of the sawing area and
clamp the sliding carriage in a stationary posi
-
tion.
Step 2: Adjust the fence to the desired cutting width.
Step 3: Place the workpiece on the saw table.
Fig. 21: Sawing operation with the saw table
Step 4: Turn on the suction device, turn on the saw, and do
the sawing.
8.3 Height adjustment
Fig. 22: Handwheel for height adjustment of the saw blade
Step 1: Loosen the handwheel clamping lever for adju
-
sting the height of the saw blade.
Step 2: Adjust the desired position of the saw blade with
the handwheel and lock the handwheel with
the clamping lever again.
8.4 Adjust inclination angle
Fig. 23: Handwheel for adjusting the angle of inclination (left)
Step 1: Release the handwheel clamping lever to adjust
the saw blade tilt angle (Fig. 23, left).
Step 2: Use the handwheel to set the desired angle of in
-
clination of the saw blade using the scale (Fig.
23, right). Then lock the handwheel with the
clamping lever again.
9 Care, Maintenance and Repair
9.1 Care after the end of work
Step 1: Disconnect the power plug from the socket.
Step 2: Empty and clean the suction device.
DANGER!
Danger of electrocution!
There is danger to life when in contact with live com-
ponents. Switched on electrical components can
cause uncontrolled movements and lead to serious
injuries..
- Before starting any cleaning or maintenance
work,switch off the machine and disconnect the po
-
wer plug.
Wear safety gloves!
NOTE!
Never use harsh cleaning agents for cleaning. This
can lead to damage or destruction of the device.