Holzmann TS 315F-1500, Руководство пользователя

Страница: 41 / 59

TROUBLESHOOTING
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 41
Formatkreissäge / panel saw TS 315F-1500
7 TROUBLESHOOTING
Disconnect the machine from the power supply prior to any checks performed at the
machine itself !
Trouble Possible cause Solution
Machine does not start  Emergency stop switch to
switch off
 switch or a phase is broken
 Overload protection is trig-
gered
.
 Safety fuse is blown
 Open cover plate for saw
blades
 Turn the emergency OFF
switch to the right to unlock
to
 Repair the defective circuit
or the faulty phase
 Wait until the engine cools
down
 Replace the fuse
 Cover plate close
Burn marks on the work-
piece
 The blade is blunt  Replace the blade
Velocity different from the
set value
 adjusted rulers  Make a right the attacks
The finished size of the
machined workpiece does
not correspond to the set
cutting width on rip fence
 Adjusted measurement
scale for the cutting width
display
 Setting dimension scale : cut
workpiece on the rip fence ,
measure the workpiece and
the measuring scale move
so that the measured aver-
age width is shown at the
edge of the ruler
Sliding table at end posi-
tions higher than machine
table
 Lower rollers set incorrectly  Adjust the lower rollers
Workpiece clamped in ad-
vancing
 dull blade
 Riving knife thickness does
not match the used blade
 Replace with sharp blade
 Splitting wedge thickness
must be greater than or
equal to blade thickness .
Broken edges on the
workpiece
 The scoring saw is not on
the same line with the main
saw
 Set the scoring saw a new