HOLZMANN MASCHINEN TS315F1600, Руководство пользователя

Страница: 34 / 58

ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 34
TS315F1600
5
6
7
6. Assembly rip fence
6.1. Ruler
 Adjust the measuring scale to the saw blade
(1) and fix it to the main table with 2 screws
M6x10.
 The measuring scale is fixed to the table ex-
tension with 2 screws M6x16, 2 washers ø6
and 2 nuts M6.
NOTE: Make sure that the measuring scale
points upwards, so that it can be read.
6.2. Rip fence guide
 Insert 4 screws (1) into the boreholes on the
main table (3) and on the table extension (4).
 2 nuts (2) are loosely screwed onto each
screw.
 Screw the four screws into the rip fence guide
with 4 - 5 turns.
 Position the two nuts (2) so that one is adja-
cent to the rip fence guide and the other to
the main table or table extension.
6.3. Assembling the rip fence support
 Loosen the star screws (5) of the rip fence
support.
 Slide the rip fence support onto the rip fence
guide (6).
 Loosen the two screws (7) of the fixing unit.
 Push the screw (slot stone) on the fixing unit
into the T-slot of the rip fence (8).
 Retighten the two star screws (5) and the two
screws (7).
6.4.
Adjustment of the rip fence
 The rip fence (8) has to be adjusted so that it
is parallel to the saw blade (7). This can be
achieved by adjusting the rip fence guide:
 Loosen the nuts (10 a,b,c,d) to be able to fit
the adjusting screws (9 a,b,c,d) by turning
them. When the desired position is reached,
tighten the nuts again.