DISPOSAL
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
25
SHT150XF | SHT300XF | SHT350XXF
19.1.1
Inspection and Maintenance Plan
Type and degree of machine wear depend on the operating conditions. The following intervals
apply when using the machine within the specified limits:
Interval
Component
What to do?
Daily or
before every
start of work
Table
Check for damage
Hydraulic system
Check for leakage
Breaks, castors
Check for correct functioning
Screws, bolts
Check for tight fit
Monthly
Moving parts
Oil/lubricate all moving parts monthly. Lubrication points: Cylinder
seat (oil); friction surfaces of the rollers (grease); hinge pins (oil);
pedal suspension point (oil); grease nipple (grease).
Annually
Hydraulic oil
Change the hydraulic oil (pump out used hydraulic fluid, fill in new
hydraulic fluid).
Hydraulic unit
Check hydraulic unit for leaks. A lifted load must not show any
discernible change in position after 10 minutes (max. 5 mm).
Hydraulic cylinder Bleed hydraulic cylinder.
Expert inspection If necessary, have an expert inspection carried out by an authorised
body.
As required
Hydraulic lines
Replace damaged hydraulic lines immediately.
20
DISPOSAL
HINWEIS
Hydraulic oils are toxic and must not be released into the environment.
When changing, use suitable collecting containers with sufficient volume!
Follow the manufacturer's instructions and, if necessary, contact your
local authority for further information on proper disposal.
Never dispose of the machine, machine components or equipment in residual
waste. Observe the national disposal regulations. In certain countries retailers
are obliged to dispose of your old machine properly, when you buy a new one.
In doubt, contact your local authorities for information on the possibilities of
legally compliant disposal.
21
TROUBLESHOOTING
WARNING
The following hazards may occur when working on the hydraulics:
uncontrolled discharge of the hydraulic fluid
accidental machine movements
flying away or bursting parts
skin diseases
Work on the hydraulics must therefore only be carried out by competent persons with
the appropriate specialist knowledge.
WARNING
Danger of crushing! Unload the table before carrying out any maintenance work.
During servicing or maintenance work on the hydraulics, there is a risk that the table
will lower from the set position. Before carrying out any maintenance or repair work
in the raised position, support the table securely!
