HOLZMANN MASCHINEN FKS 301VF-3200, Руководство пользователя

Страница: 37 / 48

HOLZMANN Maschinen GmbH www.holzmann-maschinen.at Strana 37
Formátovací pila / panel saw FKS 305VF-1600 / 2600 / 3200
15.3 Notes on using the panel saw
Cross-cutting of workpieces made of solid wood
When performing this operation, the following equipment shall be used for safe working:

The table extension

the miter gauge

the guard of the saw blade

the riving knife

the hold-down

the insert in the table
Cutting boards
When performing this operation, the following
equipment shall be used for safe working:

The table extension

the miter fence with support for the
workpiece

the guard of the saw blade

the riving knife

the hold-down

the insert in the table
In some cases, it is the cutting of laminated boards required before using the scoring
blade to prevent the demolition of the cutting edge with the main saw blade.
The scoring saw blade must be adjusted in height so
that a slot with a depth of 1 - 1.5 mm results.
 Set the guard of the saw blade.
 Carry out the work evenly, without relapses and without take it back to the end of the cutting.
 Set the saw blade so high that the ring gear is really reliably covered by the protective cover
(distance between the protective cover and the workpiece - max. 5 mm
 Perform the adjustment of the saw blade height and tilt only with the machine switched off.
Work only with good grounds tools
 Use the push rod at the end of cutting when the distance between the circular saw blade and
the parallel ruler is less than 120 mm.
 Make sure that the machine is working without vibrations.
 Cracked and deformed saw blades can not be repaired. You need to be sorted out immediately
as a committee and be replaced by ordinary.