HOLZMANN MASCHINEN FKS 301VF-3200, Руководство пользователя

Страница: 39 / 48

HOLZMANN Maschinen GmbH www.holzmann-maschinen.at Strana 39
Formátovací pila / panel saw FKS 305VF-1600 / 2600 / 3200
16.2 Maintenance
All parts (except the bearings of the main saw mandrel) should be lubricated twice weekly.
17 TROUBLESHOOTING
Disconnect the machine from the power supply prior to any checks performed at the
machine itself !
Trouble Possible cause Solution
Machine does not start  Emergency stop switch to
switch off
 switch or a phase is broken
 Overload protection is trig-
gered
.
 Safety fuse is blown
 Open cover plate for saw
blades
 Turn the emergency OFF switch
to the right to unlock to
 Repair the defective circuit or
the faulty phase
 Wait until the engine cools
down
 Replace the fuse
 Cover plate close
Burn marks on the workpiece  The blade is blunt  Replace the blade
Velocities different from the
set value
 adjusted rulers  Make a right the attacks
The finished size of the ma-
chined workpiece is incorrect
for the cutting width on rip
fence
 Adjusted measurement scale
for the cutting width display
 Setting dimension scale : cut
workpiece on the rip fence ,
measure the workpiece and the
measuring scale move so that
the measured average width is
shown at the edge of the ruler
Sliding table at end positions
higher than machine table
 Lower rollers set incorrectly  Adjust the lower rollers
Workpiece clamped while ad-
vancing
 dull blade
 Riving knife thickness does not
match the used blade
 Replace with sharp blade
 Splitting wedge thickness must
be greater than or equal to
blade thickness .
Broken edges on the work-
piece
 The scoring saw is not on the
same line with the main saw
 Set the scoring saw a new
Arm running smoothly  Telescopic tube or track rollers
dirty
 telescopic tube or track rollers
clean
 Check wipers