HOLZMANN MASCHINEN FKS 301VF-3200, Руководство пользователя

Страница: 38 / 48

HOLZMANN Maschinen GmbH www.holzmann-maschinen.at Strana 38
Formátovací pila / panel saw FKS 305VF-1600 / 2600 / 3200
 For repair and maintenance of circular saw blades with soldered fins (eg soldering new cutting
blades) the construction of the circular saw blades (tooth shape, tooth width) must not be
changed. The circular saw blades with soldered fins can be grinding up to minimum dimensions
of the plate of 1 mm
 Then the circular saw blade must be removed from service.
 Select the number of teeth of the saw blade so that at least 2-3 teeth working simultaneous-
ly). If only one tooth works, a poor working surface is, the danger of the vibrations and noise
pollution from increased setback increase.
16 MAINTENANCE
A T T E N T I O N
Don’t clean or do maintenance on the machine while it is still connected to the pow-
er supply:
Damages to machine and injuries might occur due to unintended switching on of the
machine!
Therefore: Switch the machine off and disconnect it from the power supply before
any maintenance works or cleaning is carried out
The machine is low maintenance and contains little parts that must undergo a maintenance oper-
ator.
Faults or defects that may affect the safety of the machine, must be rectified immediately.
Repair work may only be performed by qualified personnel!
The complete and utter cleaning ensures a long life for the machine and represents a safety re-
quirement.
After each shift the machine and all its parts must be thoroughly cleaned by the dust and swarf
sucked through the suction system and all other waste is disposed of by compressed air.
Check regularly that all warning and safety instructions on the machine and available in a perfect-
ly legible condition.
Check before every use the perfect condition of the safety devices.
For storage of this machine may not be stored in a humid room and must be protected from the
influence of weather conditions.
 The elimination of defects does your dealer
 Repair work may only be performed by qualified personnel!
16.1 Cleaning
N O T E
The use of solvents, harsh chemicals or abrasive cleaners leads to damage to the machine!
Therfore: When cleaning water and mild detergent if necessary use.
Bare surfaces of the machine against corrosion impregnate ( with anti-rust WD40 )