HOLZMANN MASCHINEN FKS 301VF-3200, Руководство пользователя

Страница: 30 / 48

HOLZMANN Maschinen GmbH www.holzmann-maschinen.at Strana 30
Formátovací pila / panel saw FKS 305VF-1600 / 2600 / 3200
14.1.4 Preparation of the surface
Eliminate the preservative, which is applied for corrosion protection of the parts without
painting. This can be done with the usual solvents. Here no nitro solvent or similar means,
and in no case use water.
N O T E
The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners will result
in damage to the surface!
Therefore:

When cleaning, use only mild detergent
14.2 Assembly of parts removed for transport
The sliding table saw is delivered pre-assembled. Sliding table, table top extension, rip fence,
miter gauge, and mounting guard and protective cover to be mounted
14.2.1 Mounting the slide table
 Place the sliding table to the position on the machine body.
 Then set up the terminal screws to the existing holes from. Balance the flatness of sliding table
and the machine table with shims.
 Before tightening the screws, adjust the sliding table with stop screws on the horizontal paral-
lelism.
Then bring it to the rear end plate.
14.2.2 Mounting the outrigger table

Screw at the beginning of the sliding table bracket with the
threaded rod of the swing arm.

Push the sliding table with a boom with the T-slot screws in
the sliding table you.

The sliding table bracket is screwed to the desired position
with the sliding table.

The sliding table boom on the threaded rod to the same lev-
el of machine and sliding table set.