Hologic Faxitron CT, Руководство пользователя

Страница: 15 / 79

FAXITRON CT USER MANUAL | HOLOGIC | REVISION 002
SECTION
Installation
and Setup
2
2-2
Warnings
•
Please read the instructions carefully before using the system.
•
Do not use the system in any other way than its intended use as described in this manual. If in
doubt contact Hologic or your authorised distributer.
•
Not all power cords have the same rating. Do not use any other power cord with this system
other than the one provided. Do not use the power cord from this system on any other
equipment.
•
This system is tested to the highest international standards, however it is recommended that you
contact your national authorities recording any local operational requirements.
•
This system is not intended for public use. It must be located in an area where the general public
cannot access the system without an operator being present.
General Precautions
The following precautions must be taken to prevent damage to your Faxitron CT System:
•
Never connect or disconnect communication and/or power cables, while the camera system
power is on. Damage to the CMOS detector or the camera electronics may occur if the cables are
connected / disconnected while the power is on.
•
The camera system is fragile and care should be taken in order to prevent camera damage. The
camera system must never be mishandled, hit, knocked or dropped.
•
The Faxitron CT System has a calibration mode. Calibration must be completed daily to ensure
proper system function. Please refer to the Calibration Procedure.
•
Caution
– Use of controls, or adjustments to performance of procedures, other than those
specified herein may result in hazardous radiation exposure
Interoperable Connections
The Faxitron CT is capable of operating as a standalone device without any input or output to other
devices. Images can be captured, stored and reviewed directly on the system.
However, the system does come with several interfaces. The primary one is the network
connection which allows the system to be connected to a Picture Archiving and Communication
System (PACS). Images can then be transmitted from the device directly to the facilities network
via our software in a DICOM format. See Section 6 for details on DICOM version. Only Hologic
employees or trained IT personnel at the user facility should set up this communication.
The system's connections and their intended use are listed below. No other type of devices should
be connected to the Faxitron CT without approval from Hologic.
2.1.0
System Warnings
& Precautions
Connection Purpose Device Type
Intended User
Ethernet port
at rear To store radiographic images to
networked data storage
PACS or Network
storage Set up by Hologic or facility IT personnel.
Used by clinicians.
Ethernet port
at rear To allow remote connection by the
Hologic service team, so Hologic can
diagnose and repair the system. Network internet
connection Hologic or facility IT personnel at the
direction of Hologic only.
USB port on
the font To transfer images from device. This
should only be used if PACS or network
is not available. USB storage device
(Flash Drive) Clinicians or IT personnel with approved
access to the system.
USB port on
the font To service and maintain the system. For
example, files copied to and from the
computer for software updates or to
export log files. USB storage device
(Flash Drive) Hologic or facility IT personnel