Hofmann megaspin 300, Руководство по эксплуатации

Страница: 6 / 23

6 - 0068
1.4 - SPECIFICATION
Weight with guard (excluding adapter) 108 kg version with standard spindle 300
120 kg version with pneumatic spindle 300P
Single phase power supply 115 /230 V 50-60 Hz
Protection class IP 54
Max. power consumption 500 W
Balancing speed approx. 180 r.p.m.
Cycle time for average wheel (14 kg) 6 seconds
Max. resolution of the measurement 1 gram
Position resolution ± 1.4°
Average noise level < 70 dB(A)
Distance rim - machine 0 - 267 mm
Rim width setting range 1.5" to 20" or 40 to 510 mm
Diameter setting range 10 to 24" or 265 to 615 mm
Total wheel diameter within guard 1067 mm (42")
Total wheel width within guard 500 mm
Min/max. compressed air pressure 7 to 10 kg/cm 2 (approx. 0.7 to 1MPa;
approx. 7 to 10 BAR; approx. 100 to 145PSI)
2 - HANDLING AND HOISTING
Fig.2
N.B.: NEVER HOIST THE MACHINE
USING OTHER LIFTING POINTS
3 - COMMISSIONING
3.1 - ANCHORING
The machine can be operated on any flat non-resilient floor. Make sure that the machine rests solely on the
three support points provided (fig. 2).
3.2 - ELECTRICAL CONNECTION
The machine is supplied with a single phase mains cable plus earth (ground).
The supply voltage (and mains frequency) is given on the machine nameplate. It may NOT be changed.
Connection to the mains should always be made by expert personnel.
The machine should not be started up without proper earth (ground) connection.
Connection to the mains should be through a slow acting safety switch rated at 2A amp (230V) or 4 amp
(115V) .