Hofmann megaspin 300, Руководство по эксплуатации

Страница: 13 / 23

0068 - 13
5.2.1.2 ALU-M WHEEL
(correction from the inside for two balancing planes with direct calibration):
Fig. 7
After the measurement for inside FI as shown in fig. 7, pull out the gauge further for memorizing the data
for outside FE; hold the position for at least 2 seconds.
Select pos. A or B in fig. 5 as required.
Manual presetting is possible using the buttons as described below.
5.2.2 - MANUAL PRESETTING (Use only in special cases or for checks)
- Standard wheel
Fig. 8
- Press until reading the symbol
- Preset the distance in cm of the wheel from the machine.
- Select by pressing
- Preset the nominal width which is normally stamped on the rim, or else
measure the width with the calliper gauge (standard accessory).
- Select by pressing
- Preset the nominal diameter marked on the tyre.
FE
FI