Passenger Tire Changers Service Manual 07-13 Rev.B
14
Unscrew the screws that hold the switch to the bracket and remove the switch from the bracket.
Remove the protection from the switch and disconnect the wires L1, L2 and L3 from the terminals and from the
plug.
Take a multimeter and select it in MOhm.
Place the multimeter terminals on the ends of the same
wire to check the continuity.
Cross the wire check to make sure that any wire is in short
circuit.
IMPORTANT! TO CHECK GROUND (YELLOW/GREEN)
WIRE, DISCONNECT THE WIRE END FROM THE
TERMINAL BLOCK.
TO REPLACE THE CABLE:
Release cable strain relief from the power cord.
Remove plug from cord and take the defective cable away.
Insert the new cable through the strain relief.