Passenger Tire Changers Service Manual 07-13 Rev.B
19
If there is continuity on all 3 phases replace the motor.
TO REPLACE THE MOTOR:
Place some piece of woods under the motor to avoid any
dangerous falling on the foot pedal assembly. The top one should
be longer in order to be used to lift the motor during the mounting.
Unscrew the two front bolts from the manifold to release the motor.
IMPORTANT! HOLD THE MOTOR WITH A HAND TO AVOID ANY
POSSIBILITY OF FALLING THAT COULD DAMAGE THE FOOT
PDAL ASSY.
Disconnect the wires from terminals.
Remove the pulley set screws.
Remove the pulley by using an extractor tool.
Remove the motor from its support.
Take the new motor.
Install the pulley by using rubber hammer.
NOTE:
The mounting of the new pulley must be done very carefully in
order to avoid motor bearings damaging.
NOTE:
Before connecting the wires ends, tighten all terminals nuts.
Connect the wires
FIRMLY
to motor terminals following the
voltage at which the machine is supplied.
Fix the motor on its support.
Install the motor assy on the machine and lock it firmly.
Mount the belt.
Adjust the belt tension
Plug the machine to the wall.
Turn the machine on.
MACHINE UNDER TENSION DANGER OF ELECTRIC SHOCK
Check the rotation way of the motor: If it is wrong reverse only two motor wires.
Turn the machine off and unplug it from the wall.
Mount the motor terminals cover.
IMPORTANT: WHEN REMOUNTING THE MOTOR TERMINALS COVER BE CAREFUL NOT TO CRUSH
WIRES.
Mount side panel to the cabinet.
Turn the machine on again and check if it works fine again.