HOFFEN FENK-H100, Инструкция по эксплуатации

Страница: 42 / 52

EN
[42]
STEAM IRON
temperature, set the temperature seletor button (G) to a lower temperature
and wait for the thermostat light (J) to lights up again.
Temperature selection for steam ironing
• To obtain an efficient steam output, turn the temperature seletor button
(G) to the place indicated with “MAX” inscription.
• Once the temperature light (I) turns off the iron is ready to be used, slide
the steam control button (C) to the desired position.
• After use, slide the steam control button (C) to dry ironing position.
Ironing without steam
• Make sure that the steam control button (C) is on dry ironing posit ion.
• Select the desired temperature according with the fabrics type on the
temperature seletor button (G).
Water spray
• The water spray can be used whenever desired at any temperature, as
long as there is enough water in the water tank (K). It allows moistening
the fabrics, making easier to eliminate creases.
Note: the first time the appliance is used and when it is not used for a
long period of time, it may be needed to press several times the spray
button “ ” (D), until water is released.
Steam burst
• The steam burst provides an extra amount of steam output to remove
creases or make folds, ironing lace, hanging clothes, curtains, among others.
• Turn the temperature seletor button (G) to the “MAX” position because only
this position allows the perfect steam burst.
• The temperature light (J) turns on indicating that the appliance is warming up
and will turn off when the select temperature is reached.
• Raise the iron a few centimetres above the clothing and press the steam
output button (E) to release the steam burst.
• To achieve an optimum result wait about 5 seconds between each time
the steam burst button (E) is pressed. To avoid any water leak from the