WWW.HOBBYEAGLE.COM 3 / 15
CONNECTION
Standard PWM Receiver connection
NOTES
[MODE] is used for flight mode switching of the gyro, connect it to a 3-way switch channel of
the receiver to switch the flight mode in flight.
[Serial RX/G] is used for remote master gain adjusting, connect it to a proportional channel of
a volume or slide lever of the transmitter to tune the master gain in flight.
The ESC or throttle servo is connected to the throttle channel of the receiver directly without
passing through the gyro.
Pay attention to the polarity of the plugs. The orange signal line must always be on the top and
the brown on the bottom.
Single-line Receiver Connection
A3 Pro V2 supports PPM and multi-protocol digital serial receivers which allows you to connect the gyro
to the receiver with one single wire. When using a specific type of these receivers the appropriate type of
receiver channel allocation will be preset in the A3 Pro V2. Please refer to the table below and check if
