Hobart 60CU24, Руководство по эксплуатации и техническому обслуживанию с иллюстрированным списком запасных частей

Страница: 99 / 234

OM-2098C / Operation and Maintenance Manual
60CU24 / Series 500060C / 400 Hz. Generator Set
April 01, 2005 Chapter 2-4
Page 5
(1) Warning
Warning faults are faults that occur and have no effect on the operation of the GPU. An example
would be an intake air restriction fault due to a dirty filter. Although the GPU will continue to
operate, the fault will appear on the fault code display. Pressing the “
TEST/RESET ” push button
or shutting down the GPU will reset the fault.
(2) Run Mode
Run mode faults that occur will remove power form the aircraft but will not change the operating
speed of the engine. An example would be an over voltage fault. Although the contactors will
open and remove power from the aircraft, the engine will remain at rated speed, and the fault will
appear on the fault code display, along with the appropriate command. Pressing the
“
TEST/RESET ” push button or shutting down the GPU will reset the fault.
(3) Idle Mode
Idle mode faults that occur will remove power form the aircraft and drop the operating speed of
the engine to the idle setting. A possible example (depending on customer configuration) would
be a high temperature fault. The contactors will open and remove power from the aircraft, the
engine will drop to its idle speed, and the fault will appear on the fault code display, along with the
appropriate command. Pressing the “
TEST/RESET ” push button or shutting down the GPU will
reset the fault.
(4) Stop Mode
Stop mode faults that occur will remove power form the aircraft and shut the engine down. An
example would be a low oil pressure fault. The contactors will open and remove power from the
aircraft, the engine will shut down, and the fault will appear on the fault code display, along with
the appropriate command. Pressing the “
TEST/RESET ” push button or shutting down the GPU
will reset the fault.
(5) Special Configuration
These fault codes are reserved for special customer configurations. Contact the factory for
information.
c) Fault Code Display
The numbers that appear in the “ FAULT CODE ” display are used for troubleshooting the GPU. To
read the four-digit fault code properly, it must be understood that the first two digits represent one half
of the fault code and the last two digits represent the other half.
•
The first two digits on the left side of the Fault Code represent the Command .
•
The two digits on the right side of the Fault Code represent the Fault Condition.