Hobart 60CU24, Руководство по эксплуатации и техническому обслуживанию с иллюстрированным списком запасных частей

Страница: 138 / 234

OM-2098C / Operation and Maintenance Manual
60CU24 / Series 500060C / 400 Hz. Generator Set
April 01, 2005 Chapter 3-2
Page 4
3) Coupling Service
When ordering coupling kits or other parts from your ITW GSE Group Distributor, be sure to include all
pertinent information from the unit’s identification plate: Specification No., Model No., and unit rating.
If you have any questions concerning your ITW GSE Group equipment, immediately contact our Service
Department by mail, telephone, e-mail, or FAX.
Write: ITW GSE Group
Hobart Ground Power
Service Department
1177 Trade Road East
Troy, Ohio 45373
U.S.A.
Call Inside U.S.A.: (800) 422-4166 (Parts)
(800) 422-4177 (Service)
Call From Foreign Countries: (937) 332-5050 (Parts)
(937) 332-5060 (Service)
FAX Inside U.S.A. (800) 367-4945
FAX From Foreign Countries: (937) 332-5121
E-Mail : service@itwgsegroup.com
Web Page : www.itwgsegroup.com
a) Replacement Coupling Kit
A replacement coupling kit is available from your ITW GSE Group Distributor. This kit provides a
replacement coupling assembly with attaching hardware and installation instructions.
b) Bushing Kit
A bushing kit is available from the ITW GSE Group for replacing the rubber bushing only in the
coupling assembly. However, it should be noted that the finished coupling assembly must be
balanced to 1/2 inch-ounce
(360 mg-m) minimum, which may be a problem in the field. If bushing
replacement only is required, the kit part number is 480290. Each kit contains the required number of
bushings, a container of lubrication, and installation instructions.
c) Bushing Replacement
To replace bushings only, proceed as follows:
(1) Press out ALL old bushings.
(2) Refer to Figure 4. Clean each bushing socket thoroughly, removing all traces of old rubber. DO
NOT scratch or deform the bore of the bushing socket.