Hobart 60CU24, Руководство по эксплуатации и техническому обслуживанию с иллюстрированным списком запасных частей

Страница: 40 / 234

OM-2098C / Operation and Maintenance Manual
60CU24 / Series 500060C / 400 Hz. Generator Set
April 01, 2005 Chapter 1-2
Page 2
c Engine lubricating oil level
The oil gage rod has “H” high mark and “L” low level marks to indicate the operating
lubrication oil supply. Oil level should be kept as near the high mark as possible, without
going over it. See Figure 1 for capacity.
CAUTION
NEVER operate the engine with oil level below the “ L” level mark or above the ”H”
level mark.
NOTE: See the Engine Manufacturer’s Operation Maintenance Manual for oil recommendations.
Oil Fill
Oil Level Check
Oil Fill and Oil Level Check Locations
Figure 2
d Check Batteries
Inspect the batteries for proper connection of the terminals and also check the electrolyte
level (if possible). Service or replace if necessary.
b) Installing Three-Phase AC Output Cables
The generator set may be shipped without aircraft cables. The load contactors, to which cables must
be connected, are located on the power module assembly (left side of the unit beneath the engine
control panel).
The conductor size recommended for AC output cables is 2/0 AWG. Use No. 12 size for control (E
and F) terminals. Large cables (A, B, C, and N) should be equipped with terminals having at least a
3/8-inch diameter, mounting holes. Mounting holes in the small leads (E and F) should be at least
1/4-inch diameter.