Anybus Configuration Manager (MAPS)
25 (32)
5.4
Signals Tab
This section contains settings for the signals on both protocols.
Fig. 17
Signals tab
5.4.1
Common and KNX Signal Parameters
The following common and KNX specific parameters can be configured for each signal.
Active
If checked, the signal will be considered in the configuration and will be downloaded to
the Gateway as active.
Description
A short description of the signal.
Data Type
EIS data type corresponding to the selected DPT column. Not editable, just for
information.
DPT
Select the KNX Data Point Type (DPT) to be used for each signal or KNX communication
object.
Sending
KNX sending group address associated to the communication object. 2 (P/S) and 3 (P/I/S)
level format is supported.
Listening
5.
KNX listening group address associated to the communication object. 2 (P/S) and 3
(P/I/S) level format is supported. More than one group address can be used,
comma separated.
U
If selected, the KNX Communication Object will be updated after a KNX bus failure.
T
If selected, the KNX Communication Object will be updated when a transmit telegrams
are sent from KNX.
Ri
If selected, the KNX Communication Object will be updated on initialization.
W
If selected, the KNX Communication Object is ready to be written from KNX.
R
If selected, the KNX Communication Object is ready to be read from KNX.
Priority
Define the KNX priority for each KNX Communication Object.
Values from 0 to 3, where 0 is the highest priority.
Modbus to KNX Gateway User Manual
SCM-1202-050 1.2 en-US
