HME System 500, Руководство по эксплуатации

Страница: 15 / 22

13
D. Speed-Team Operation
Speed team operation is used during high-volume times. An order
taker wearing an HS500 headset relays orders from outside into
the store, using button B on the headset. Placing the speed-team
switch, on the bottom of the base station, in the ON position
will disable the outside speaker/microphone and the vehicle-alert
tone.
IV. EQUIPMENT CARE AND CLEANING
A. Proper Handling
•
When adjusting microphone position, hold boom at base, not at
microphone end.
•
Carry headset by headband, not by earpiece or battery end, and
never by microphone boom.
•
Use both hands to put headset on or take it off.
B. Cleaning
1. Headsets
•
Remove batteries from headsets.
•
Clean batteries and headsets with damp sponge sprayed with
household cleaner. Squeeze excess liquid out of sponge
before using it.
•
Clean metal contacts on batteries and headsets as follows.
Wet tip of swab with alcohol and squeeze excess alcohol
from it. Wipe each contact with swab and be certain all
contacts are dry before reinstalling batteries in headsets.
•
Foam muffs on headset earpieces can easily be replaced for
sanitary purposes. To order extra foam muffs, call your
local HME sales representative.
2. Battery Charger
Avoid splashing water or grease on the battery charger. Clean
the battery charger monthly as follows.
CAUTION: Always unplug the battery charger before cleaning
it.
•
Remove all batteries from the battery charger.
•
Clean the battery charger case with a damp sponge. Wet the
sponge and wring it out so it is damp, not dripping wet.
Spray household cleaner on the sponge (NOT DIRECTLY ON THE
EQUIPMENT). Clean the battery charger with the sponge and
dry it thoroughly.
•
Wet the tip of a cotton swab with rubbing alcohol and
squeeze the excess alcohol from the swab. Wipe the metal
contacts inside each battery port with the damp swab.
Allow the contacts to dry before placing batteries in the
ports.