HME System 500, Руководство по эксплуатации

Страница: 11 / 22

9
C. Battery Charger
Up to four headset batteries can be charged in the charger at the
same time. Battery charging time is approximately 2 hours. The
battery status lights adjacent to each charging port are
explained below. Up to six fully charged batteries can be stored
in the battery storage ports.
•
Insert a battery in one of four charging ports until it clicks
in place.
•
The yellow light next to each battery port stays on while the
port is empty.
When a battery is in a port, a yellow light flashing next to
it indicates CHARGE PENDING, which means the temperature where
the charger is located is out of the battery’s operating range
(32
o
-104
o
F, 0
o
-40
o
C). Adjust the room temperature or move the
charger to a cooler area.
When battery is in port, yellow light on steady next to
battery port means CHARGE FAILED. Follow diagnostic
instructions on side of battery charger.
•
The red CHARGING light next to each battery port stays on
while a battery in the port is charging.
•
The green READY light next to each battery port goes on when a
battery in the port is fully charged.
•
Remove the fully charged battery from its charging port and
place it in a storage port.
CAUTION: Do not remove batteries from the charger until the
green READY light is lit, or the charger will reset and the
charge cycle will begin again.
Battery in
storage
port
Battery in
charging
port