Assembly instructions
General
HIWIN MAGIC Distance Measuring Systems
MAGIC-01-14-EN-2207-MA
Page
5
of
32
1.2
Presentation and layout conventions used in these assembly
instructions
1.2.1
Instructions for actions
Instructions for actions are provided in sequential order and identified with a triangle symbol.
The results of the actions are accompanied by a tick symbol.
Example:
Fix the encoder by tightening the screws
[7]
with 1
Nm.
Fasten the wiper
[14]
to the MAGIC-PG encoder using screws
[11]
, nuts
[10]
and lock
washers
[9]
in such a way that the sealing lip rests lightly against the rail contour on all
sides.
The new encoder is mounted.
1.2.2
Lists
Lists are identified through the use of bullet points.
Example:
It is available in two versions:
HIWIN MAGIC: type with separate encoder
HIWIN MAGIC-PG: distance measuring system integrated in a linear guideway
…
1.2.3
Presentation of safety information
Safety notices are always indicated by a signal word and sometimes with a hazard-specific
symbol (see section 1.2.4 Symbols used).
The following signal words/hazard levels are used:
Danger!
Immediate danger!
Failure to follow this safety instruction will result in severe or fatal injury!
Warning
! Potentially dangerous situation!
Failure to follow this safety instruction could result in severe or fatal injury!
Attention!
Potentially dangerous situation!
Failure to follow this safety instruction could result in moderately severe or minor injury!
Caution!
Potentially dangerous situation!
Failure to follow this safety instruction could result in damage to property or the environment!
1.2.4
Symbols used
The following symbols are used in these assembly instructions and on the linear axes:
Warning symbols
Warning of dangerous
electrical voltage!
Environmentally
hazardous substance!
1.2.5
Information
Note:
Provides general information and recommendations.
