Hiwin IM-2-13, Инструкция по сборке

Страница: 34 / 84

Assembly Instruction Motor Interface Design
Torque Motor TM-Komponenten-04-0-EN-2108-MA Page 34 of 84
4 Motor Interface Design
4.1 Water cooling design
HIWIN torque motor can be cooled by water or air. (TM-2 and IM-2 are only available with water-cool) Water
cooling channel is designed on the outer case of stator. O-ring is installed outside the water cooling channels as
a leak-proof device. To ensure a good circulation of the coolant for cooling, the design coolant inlet and outlet
must be aligned with position on the approved drawing.
Fig. 4.1: Basic structure of HIWIN torque motor
4.1.1 Water cooling channel position
The recommended coolant inlet/outlet position for each series is given as below.
Table 4.1: TMRW series coolant inlet/outlet position
L (mm) ΔS (mm)
20 40 60 90 140
25 TMRW13(L)
TMRW43(L) TMRW15(L)
TMRW45(L) TMRW17(L)
TMRW47(L) TMRW1A(L)
TMRW4A(L) TMRW1F(L)
TMRW4F(L)
30 TMRW23(L) TMRW25(L) TMRW27(L) TMRW2A(L) TMRW2F(L)
35 TMRW73(L)
TMRWA3(L) TMRW75(L)
TMRWA5(L) TMRW77(L)
TMRWA7(L) TMRW7A(L)
TMRWAA(L) TMRW7F(L)
TMRWAF(L)
43 TMRWD3(L) TMRWD5(L) TMRWD7(L) TMRWDA(L) TMRWDF(L)
35 TMRWG3(L) TMRWG5(L) TMRWG7(L) TMRWGA(L) TMRWGF(L)
Table 4.2: TM-2/IM-2 series coolant inlet/outlet position
L (mm) ΔS (mm)
20 40 60 90 140
25 □ M-2-13
□
M-2-43
□ M-2-15
□
M-2-45
□ M-2-17
□
M-2-47
□ M-2-1A
□
M-2-4A
□ M-2-1F
□
M-2-4F
30 □ M-2-23 □ M-2-25 □ M-2-27 □ M-2-2A □ M-2-2F
35 □ M-2-73
□ M-2-A3
□ M-2-75
□ M-2-A5
□ M-2-77
□ M-2-A7
□ M-2-7A
□ M-2-AA
□ M-2-7F
□ M-2-AF
43 □ M-2-D3 □ M-2-D5 □ M-2-D7 □ M-2-DA □ M-2-DF
35
□
M-2-G3
□
M-2-G5
□
M-2-G7
□
M-2-GA
□
M-2-GF