Assembly Instruction
Introduction
Torque Motor
TM-Komponenten-04-0-EN-2108-MA
Page 11 of 84
It is recommended to install the rotor immediately after unpacking!
When installing the stator and rotor, an installation auxiliary device is required to assemble the stator and
rotor individually. Please follow the correct method.
Keep the following tools at hand at any time to release body parts (hands, fingers, feet, etc.) clamped by
magnetic force.
–
Hammer made of non-magnetized solid material (about 3Kg)
–
Two wedge blocks composed of non-magnetized materials (wedge-shaped sharp angle 10°~15°,
minimum height 50mm).
1.3.8
Wiring precautions
1
Before using the product, carefully read through the specification noted on product label, and ensure the
product is used with power supply specified in product requirement.
2
Check if the wiring is correct. Incorrect wiring may make the motor operate abnormally, or even cause
permanent damage to the motor.
3
Select extension cord with isolation net. The isolation net must be grounded.
4
Do not connect power cable and temperature sensor cable to the same extension cord.
5
Power cable and temperature sensor cable contain isolation net. The isolation net must be grounded.
1.3.9
Operation precautions
1
Avoid excessive friction when the motor is running.
2
Ensure there is no object in the motion range of the system.
3
Before starting the motor, ensure the water cooling system works properly.
4
Before starting the motor, ensure the main switch is on.
5
Before transmitting electricity, ensure at least one ground wire is connected to all electrical products.
6
Do not directly touch motor parts after motor is assembled.
7
If the current exceeds the maximum specified current, magnetic components in the motor may be
demagnetized. When it happens, please contact HIWIN or local distributors.
8
Do not operate the product in an environment that exceeds its rated load.
9
When the motor is running, its temperature must be within the specification.
10
If any abnormal odor, noise, smoke, temperature rise or vibration is detected, stop the motor and turn off
the power immediately.
11
Fixed operation environment conditions must comply with EN 60721-3-3 (Please refer Table 1.3).
Содержание IM-2-13
Страница 1: ...MW99UE01 2104 Assembly Instruction Torque Motor TM Komponenten 04 0 EN 2108 MA www hiwin de...
Страница 83: ...Assembly Instruction Declaration of Incorporation Torque Motor TM Komponenten 04 0 EN 2108 MA Page 83 of 84...
Страница 84: ...Assembly Instruction Declaration of Incorporation Torque Motor TM Komponenten 04 0 EN 2108 MA Page 84 of 84...
