Hiwin HM-S, Руководство по сборке

Страница: 15 / 100

Description of the HM-S linear modules and HT-S linear tables
15
Assembly Instructions
Linear Axes HM-S and HT-S
HMS_HTS-01-0-EN-1905-MA
3.2.5 Order code for linear tables HT-S
Order code for linear tables HT-S (continuation)
1) Detailed information in Section 4.5 or in the assembly instructions “HIWIN MAGIC Positioning Measuring Systems”
2) If no drive interface is selected, the order code ends at this position
3) All flange types can be found in Section 11.1 on Page 73 ff.
If no flange type is selected, the order code ends at this position
4) Suitable HIWIN motors can be found in the catalogue “Drives and Servo Motors”
5) Further reference switches on request
Carriage length:
S: Short
Stroke length [mm]
Cover strip:
C: With steel cover strip
N: Without cover strip
HT 150 S 010 C 1234 S
HIWIN linear table
Size (profile width):
100: 100 mm
150: 150 mm
200: 200 mm
250: 250 mm
Drive type:
S: Ballscrew
Spindle lead [mm]:
005/010/016: HT100S
005/010/020: HT150S
005/010/025: HT200S
010/020/032: HT250S
Motor 4)
Flange type of motor 3)
A N N S HW05 FRLS2020506A
Axis limit switches 5) :
N: Without limit switches
A: 2 × NC, 100 mm cable, plug
C: 2 × NC, 4 m open cable end
D: 2 × NO, 5 m open cable end
Spindle support:
N: Without spindle supports
1: One spindle support per side
2: Two spindle supports per side
3: Three spindle supports per side
4: Four spindle supports per side
Optional positioning measuring system
1)
:
N: Without positioning measuring system
A: Positioning measuring system with analogue signal
D: Positioning measuring system with digital signal
Drive interface
2)
:
N: None
S: Straight
L: Left
R: Right
A: Top
B: Bottom
N S L R A B