8 Channel 2.4 GHz Aircraft Computer Radio System
8 Channel 2.4 GHz Aircraft Computer Radio System
Section 6: Heli Programming Menu
Section 6: Heli Programming Menu
108
109
Flight Conditions cont.
2. Scroll to the flight condition to be configured and press the
jog dial to confirm your selection.
3. Press the jog dial again to activate the switch selection menu
(not applicable in “Normal” flight condition).
4. Rotate the jog dial to select the switch that you will use to
activate this flight condition and press the jog dial to confirm
your selection.
a. If “NULL” is selected, the flight condition will be inactive.
b. If you selected a switch, the switch position menu will appear.
- Scroll to highlight the switch position that you will use to
enable the flight condition. Press the jog dial to confirm your
selection.
- Rotate the jog dial to select “ON” and press the jog dial to
confirm your selection. If you toggle the selected switch, the
field in the top right corner of the screen will indicate which
flight condition is active.
- Press the back button twice to return to the flight conditions menu.
If the more than one flight condition is concurrently enabled, the condition with the highest number
(per the table shown above) will be active. The field just below the model icon on the Home screen
indicates the active flight condition.
Note
Tip
Tip
Tip
5. Scroll to highlight the “SPEED” field and press the jog dial to
activate the menu.
Flight Conditions cont.
Swash Ring
The Swash Ring Mix limits the travel of the servos attached to the helicopter swash plate. This can be used
to help prevent binding of the control system when using large control movements for aerobatics.
To configure swash ring:
1. From the model menu, rotate the jog dial to highlight “Swash
Ring” and press the jog dial once to enter the activation menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select ACT (activate), then press the jog
dial to confirm your selection and activate the Swash Ring mix.
4. Press the jog dial to enter the “RATE” menu.
5. Rotate the jog dial to set the value that you want limit swash
(aileron and elevator) channels. Press the jog dial to confirm
your selection.
6. The “AILE” and “ELEV” fields are for display only. They show the value of the aileron and elevator
channels as you actuate the relevant controls. These values are reflected in the graph as well.
7. Press the back button to return to the model function menu.
To disable the swash ring:
1. Scroll to highlight the “MIX” field in the pitch curve menu and
press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to confirm your
selection.
3. Press the Back button to return to the model function menu.
6. Rotate the jog dial to define the amount of time (0.0 to 10.0
seconds) to transition the settings when this flight condition is
enabled. Press the jog dial to confirm your selection. This feature
can be utilized to prevent sudden control surface movements
when switching between flight conditions.
7. Press the back button to return to the flight conditions menu and repeat steps 2-6 to define further
flight conditions.
8. Press the back button twice to return to the model function menu.
