8 Channel 2.4 GHz Aircraft Computer Radio System
8 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
Section 5: Acro and Glider Programming Menu
66
67
Elevon Mixing cont.
15. If aileron or elevator functions operate in the incorrect
direction, highlight the direction field (“nor”) under the function
name and press the jog dial to activate the menu.
16. Scroll to select “rev” and press the jog dial to confirm your
selection. Verify that the control surfaces now move in the correct
direction.
17. Push the Back button twice to return to the model function
menu.
If you are using multiple flight conditions, you must define elevon values for each flight condition.
The top field of the Elevon Mix menu allows you to select the desired flight condition. Alternately,
you may select the desired flight condition using the assigned F.Cond switch.
Note
Tip
Tip
Tip
V-Tail Mixing
Aircraft with a V-tail configuration can use this function to specify the limits of travel for both tail control
surface servos.
2. Scroll to the top “ELEV” field and press the jog dial to activate the
menu.
3. Scroll to highlight the “L/U” (left/up) field and press the jog dial
to activate the menu.
4. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo attached
to the “ELEV” receiver slot. This value regards the servo travel
when a pitch up command is given. Press the jog dial to confirm
your input.
1. From the model menu, rotate the jog dial to highlight “V.Tail Mix”
and press the jog dial once to enter the V-tail mix menu.
5. Scroll to highlight the “R/D” (right/down) field and press the jog
dial to activate the menu.
6. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a pitch
down command is given. Press the jog dial to confirm your
input.
7. Press the back button to return to the V-tail menu.
8. Scroll to the top “RUDD” field and press the jog dial to activate
the menu.
V-Tail Mixing cont.
9. Scroll to highlight the “L/U” (left/up) field and press the jog dial
to activate the menu.
10. Rotate the jog dial to increase (clockwise) or decrease (counter-
clockwise) the desired endpoint for the servo attached to the
“RUDD” receiver slot. This value regards the servo travel when a
pitch up command is given. Press the jog dial to confirm your input.
11. Scroll to highlight the “R/D” (right/down) field and press the
jog dial to activate the menu.
12. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a pitch
down command is given. Press the jog dial to confirm your
input.
13. Press the back button to return to the V-tail Mix menu.
14. Repeat steps 2-13 using the lower “ELEV” and “RUDD” fields to set servo endpoints when yaw (rudder)
commands are given.
15. If elevator and/or rudder functions operate in the incorrect
direction, highlight the direction field (“nor”) under the reversed
function and press the jog dial to activate the menu.
