General information
Note:
You can switch on with
STANDBY
m
, the number
buttons
0-9
or by putting in a cassette.
* If you have not used the video recorder for a few minutes,
it will switch to standby automatically. For more information,
please read the section ’Automatic switch-off’ in chapter
’additional functions’.
* If you have switched the video recorder off with
STANDBY
m
, the time will show in the display, for instance ,
’18:00’.
If the clock has not been set, ’
--:--
’ will appear.
* When the video recorder is switched off and the time isn’t
shown in the video recorder display, the clock display may
be switched off. You will find more information in the
section ’Saving energy’.
* Keep your video recorder connected to the mains at all
times to ensure that programmed recordings can be made
and that the television works normally. Your video recorder
uses less than 4 Watts (with clock-display switched off).
* If the video recorder is not plugged into the mains, it will
usually store TV channels for one year and timer and date
information for three hours.
Saving energy
To save energy, you can switch off the clock display on the
video recorder. Programmed (TIMER ) recordings will take
place even if the clock display has been switched off.
1
Switch on the TV set. If required, select the programme
number for the video recorder.
2
Press
MENU
on the remote control. The main menu will
appear.
3
Select the line ’
SPECIAL SETTINGS
’ with
P-
=
or
;
P+
and confirm with
OK
.
SPECIAL SETTINGS
OSD
è ON
p
CLOCK DISPLAY
OFF
COUNTER
T.LEFT
SAT RECORDING
OFF
REPEAT PLAY
OFF
DIRECT RECORD
OFF
________________________________
EXITpMENU
STOREpOK
4
To switch off the clock display on the video recorder,
select ’
OFF
’ in line ’
CLOCK DISPLAY
’ with
P
.
Note:
To switch the clock display on, select ’
ON
’.
5
Confirm with
OK
.
’
STORED
’ will briefly appear on the TV screen.
6
To end, press
MENU
.
Emergency interrupt
You can use
STANDBY
m
on the video recorder or the remote
control to interrupt any function.
So if you are having operating problems, you can just interrupt
the function and start again.
And you can practise operating your set without any worries.
No matter which buttons you press, you cannot damage it.
3.
IMPORTANT NOTES FOR OPERATION
9
