Hitachi Summit RAC-50YH5, Руководство по обслуживанию

Страница: 66 / 113

– 78 –
DC 260-360V is input to system power module and system power module switches power supply current
according to rotation position of magnet rotor. The switching order is as shown in Fig. 3-2.
E F
U V V W
Upper arm
transistor
Lower arm
transistor
Time
+ +
T
+
+
T
U Ð V Ð W Ð
U transistor chopped
U transistor ON
ON
Voltage at
Upper arm transistor
Current at
Chopping period
260V-360V
A
+
-
B
At point E: U+ is ON, VÐ is ON (circuit in Fig. 3-1)
At point F: U+ is chopped (OFF), VÐ is ON (circuit in Fig. 3-4)
[ ]
Upper arm transistor is controlled to ON/OFF by 3.3kHz chopper signal. Rotation speed of the compress
is proportional to duty ratio (ON time/ ON time + OFF time) of this chopper signal.
Time T in Fig. 3-2 shows the switching period, and relation with rotation speed (N) of the compressor is
shown by formula below;
Fig. 3-2 Switching order of power module
N = 60/2 X 1/T
Fig. 3-3 shows voltage waveform at each point shown in Figs. 3-1 and 3-4. First half of upper arm is
chopper, second half is ON, and first half of lower arm is chopper, second half is ON.
Fig. 3-3 Voltage waveform at each point
When power is supplied U+ UÐ, because of that U+ is chopped, current flows as shown below;
(1) When U+ transistor is ON: U+ transistor U coil V coil VÐ transistor DC current detection
resistor Point (Fig. 3-1)
(2) When U+ transistor is OFF: (by inductance of motor coil) U coil V coil VÐ transistor Return
diode Point (Fig. 3-4)
A
B
B