Hitachi PH, Инструкция по эксплуатации

Страница: 50 / 288

● Connection of signals 1-39
● The voltage and current used by the external device must meet the following
specifications.
IL
≦
20mA (V
CE
: TYP0.6V, MAX2V)
The IL maximum permissible current is 50 mA.
Vd
≦
DC30V
(b) Changeover between printing-in-progress and printing-complete
Perform printing-in-progress/printing-complete signal changeover setup from
the user environment setup screen.
(See Section 4.2, Setting the User Environment).
(c) Signal timing
Printing operation
Printing in progress
signal
Printing-complete
signal
Printing-
complete signal
ON
OFF
ON
OFF
more than 1 sec
Less than 1 sec
1 sec
*
* The printing-complete signal turns OFF when the next print-
ing operation starts within an elapse of less than 1 second.
1.5.3-9 Input for remote control signals
These connection terminals enter actions corresponding to the run-state operation
keys of the IJ printer (Run, Stop, fault Clear, and Deflection Voltage Control
(switchover between a standby state and a ready state), by means of external switches,
contact signals, or something similar.
(a) Input specifications
・
Make inputs by no-voltage contacts.
・
In the case of no-contact, use terminals that satisfy the following requirements:
Withstanding voltage: 12 VDC or more
Maximum driving current: 12 mA or more
Residual voltage: 2 V or less
Leak current: 0.1 mA or less
Driving method: Open collector
・
In the case of contact signal
In the case of the chattering when contact is ON or OFF , use terminals of 2.0
ms or less.
(No-voltage contact)
The current applied to the
system is about
12 mA.
+12V
13
10
14
15
16
Signal ground
High-voltage ON/OFF
Run
Reset (Clear)
Stop
TB1
GND
The same holds true for
the other signals.
?
When all input contacts are ON, the system runs in the same manner as when the
Run,Clear, Stop, or Deflection Voltage Control key is pressed.
*