Hitachi PH, Инструкция по эксплуатации

Страница: 106 / 288

● Setting Repeat Printing 3-38
3.5 Setting Repeat Printing
(1) Overview
● This is set to print the same print description continuously.
● Set the "Repeat intervals" and "Repeat count" for repeat printing.
Repeat intervals
● The print target size can be specified.
● This setup is to be performed when the print target is transported while it is in
close contact.
● Perform the following calculations for repeat intervals setup purposes.
(i) On an individual scan basis
(1-digit character width×number of digits - trailing character correction value)
× (print target size/all-digit print width)
(ii) On an individual character basis
Number of digits × (print target size/all-digit print width)
(Example) Print target size: 64 mm; all-digit print width: 25 mm;
number of digits: 6; character size: 5 × 7 dots; inter-character
space: 2 dots
On an individual scan basis
((5+2)×1×6?(2×1+1))×(64/25)=99.84
→ 100
On an individual character basis
6×(64/25)=15.36
→ 15
● Round off the calculation results to the nearest whole number.
.
.
Print target Print target
Repeat intervals
Repeat count
● You can preset the number of repeat printing sequences to be performed while the
sensor light is blocked.
● If repeat printing is not needed, select the number "0".
● Printing is performed in accordance with the repeat printing mode setup.
● The relationship between repeat printing mode and count is as stated below.
Mode
Setting
2 to 9998 9999
Signal ON
period
Printing is repeated a
preselected number of times
at predefined intervals while
the print target is detected.
Repeat printing is performed
while the print target is
detected.
OFF - ON
transition
Printing is repeated a
preselected number of times
at predefined intervals once
the print target is detected.
Once the print target is
detected, repeat printing is
performed until it is aborted.
1-digit character width
= (horizontal character
size + inter-character
space) x character
width increase setting
Trailing character
correction value =
intercharacter space x
character width
increase s 1
1
2