INSTALLATION OF REMOTE CONTROL SWITCH <PC-2H2>
2
1.1.
BEFORE INSTALLATION
Check the contents and the number of the accessories in the
packing.
1 Remote Control
Switch, for Operation
Control
2 screws ø4x16L
For fixing the
Holding Bracket
onto the wall
1 Remote
Control Cable
(8 m) for
connection
1 Ring Core
and
1 Fixing Band
1.2.
INSTALLATION SPACE
In case of installing the controllers in vertical line, keep a
distance more than 10 mm between the controllers vertically. If
the distance is insufficient, the front cover of the controller can
not open wide enough
Fig. 1 Installation Space
1.3.
INSTALLATION PROCEDURE
1. Insert the edge of the flat head screwdriver into the dent
parts at the bottom of the holding bracket, push and turn
the screwdriver and remove the controller from the holding
bracket as shown in the figure below.
Fig. 2 Installation Procedure
Fig. 3 Installation Procedure
2. Attach the controller to the holding bracket as follows.
A. In case of exposing Remote Control Cable.
É
Fix the holding bracket onto the wall as shown below
Fig. 4 Attach the controller
Ê
Make the hole for drawing out the cable
Select the position for drawing out the
cable among 3 positions marked with *
and make the knock-out hole by cutting off
with a cutter or so. Two sizes of the line for
the knock-out hole are prepared, and the
inner line is for the cable.
Fig. 5 Drawing out the cable
Controller
Dent
part
Holding
Bracket
Dent part
Holding
Bracket
Screwdriver
Holding Bracket
Dent part
Fix the holding bracket with
the mark "
↑
UP" upward
Screw
(Accesory)
Dent
part
Bottom view
More Than 10 mm
Screwdriver