-11-
Fig. 3
Fig. 4
Next, use your fingers to extract the rubber Cap
[18]
sideways from the Lever (C)
[22]
. Remove the Special
Bolt M5
[21]
. The Blade Holder (C)
[5]
, Lever (C)
[22]
, Blade Spring
[23]
, Holder Pin (B)
[19]
, and Spring
(B)
[20]
can now be removed from the Plunger (F)
[12]
.
Be careful not to lose or damage the Spring (B)
[20]
.
Remove the Plunger (F)
[12]
from the Gear Cover (F)
[4]
, and then remove the Connector Pin (F)
[13]
and
two Swing Rollers
[14]
.
Be careful not to damage the Felt Washer
[6]
, V-Ring
[8]
, and O-Ring
[9]
.
As the Metal (B)
[10]
is press-fit into the Gear Cover (F)
[4]
, use a press or similar tool to push it out of
position. Then remove the V-Ring
[8]
, Washer (H)
[7]
, and Felt Washer
[6]
. Use a thin flat-blade
screwdriver or similar tool to remove the O-Ring
[9]
inside the Metal (B)
[10]
. Then remove the three Nylock
Bolts (W/Flange) M4 x 12
[25]
and remove the Ball Bearing 6002DDCMPS2L
[24]
.
Blade Holder (C)
[5]
Plunger (F)
[12]
Lock Nut M5
[11]
Blade Spring
[23]
Swing Roller
[14]
Connector Pin (F)
[13]
Nylock Bolts (W/Flange) M4 x 12
[25]
Ball Bearing 6002DDCMPS2L
[24]
Sub Shaft (B)
[26]
Cap
[18]
Special Bolt M5
[21]
Holder Pin (B)
[19]
Spring (B)
[20]
Lever
[22]
Gear Cover (F)
[4]
Gear Cover (F)
[4]
Felt Washer
[6]
Washer (H)
[7]
V-Ring
[8]
O-Ring
[9]
Metal (B)
[10]
