INSTALL THE UNIT IN AN ADEQUATE ENVIRONMENT !
DO NOT expose this monitor to rain or moisture to prevent electric shock or fire hazard.
This unit is designed to be used in an office or business environment.
DO NOT subject the unit to vibrations, dust, or corrosive gases.
KEEP IN A WELL VENTILATED PLACE !
DO NOT cover this monitor or place anything against any sides (not only top, right and left
side but also rear and bottom side) of unit. Ventilation holes are provided at all sides of the
rear cover to prevent the temperature from rising.
KEEP AWAY FROM HEATING RADIATION OR SOURCE !
AVOID placing the unit in direct sunshine or near a heating appliance.
BE CAREFUL OF MAGNETIC FIELDS !
DO NOT place a magnet, loudspeaker system, floppy disk drive, printer, or anything which
will generate magnetism near the unit.
A magnetic field may cause blurred
or
distortion of the displayed pattern.
Make sure the Power Switch is “OFF”.
Make sure to use a power cord meeting the safety standard of the
country, in which you are using the monitor.
Connect a power cord to the “AC Inlet” of the monitor.
Connect the plug of the power cord to a receptacle of the correct
voltage.
In USA/Canada, use a UL
or CERTIFIED power cord set meeting the
following specifications.
Rating: min.
7A
Length: max. 3.1 m
Type: SVT or SJT
Plug type: NEMA
Parallel blade, Grounding type,
15A
Failure to do so may cause fire or electric shock hazard.
In Europe, a proper European standard approved power cord is to be used with this
monitor. For a rated current up to 6 A, a type not lighter than
0.75
or
3G 0.75
shall be used.
The enclosed power cord shall be used if provided.
Use only the correct voltage power outlet with safety ground connection.
100 120 V for USA, Canada, etc.
200 240 V for Europe, etc.
(This monitor automatically
adjust to
the input voltage 100
200 240V.)
The receptacle should be close to the monitor and easily accessible.
7
