When the Function
Control buttons are not used for more
than 15 seconds, the current value of Brightness, Contrast and Colour
Select are automatically stored.
The previous data of Brightness, Contrast and Colour Select are overwritten when the
current value is stored.
If you press [Store] button, the current value is stored immediately. The current value is
not stored if you power off before 15 seconds passed.
l
Store the adjusted data by pressing the button [STORE I.
value can be stored for the
Rotation,
(Red, Green and Blue)
Colour balance is stored in the
Contrast, Brightness, Colour Select
These are usually stored automatically. Refer
to “AUTOMATIC STORE”.
Cl When a new value is stored, the previous data is
overwritten.
@One adjusted value for each video mode can be stored for the functions
below.
Horizontal Position
Pincushion, Trapezoid,
Horizontal Size, Vertical Position, Vertical Size,
The latest setting is restored to the image automatically when the same video mode is
used. Refer to “AUTOMATIC SETTINGS”
When a new value is stored in one video mode, the previous data in the video mode is
overwritten.
q
The geometry for each standard video mode has been preset. (refer to ‘STANDARD
SETTINGS”) The user settings are available for up to 13 video modes.
q
The video mode is detected by the horizontal vertical frequency and polarity of the
horizontal vertical sync. signal. If two video modes are similar, much, there is a
possibility that they will not be identified as different.
Storing a setting for a 14th video overwrites the oldest one.
ON the power switch while pressing the
button
ADJUST
+ and
ADJUST
together,
to reset to the original standard settings.
(at the power
only)
Use this function only when you want to cancel all your
. All your storing data will be lost and the all adjustment
I
I
be original.
.
.
If you perform this function the reset will take approximately
10 seconds.
