--- 16 ---
(6) When installing the Plunger Holder Ass'y [35]
in the Upper Cover [33], ensure that the
O-Ring [57] is properly mounted at the lower
portion of the Plunger Holder Ass'y [35], as
shown in Fig. 16. Also, ensure that the two
Springs [34] are properly mounted between
the Plunger Holder Ass'y [35] and the Upper
Cover [33] (Fig. 16).
Fig. 16
Upper Cover
[33]
Spring [34]
Plunger Holder
Ass'y [35]
O-Ring [57]
(3) Carefully ensure that two Washers (A) [44], the
Orbital Cam [46], and the three Balance Weights [45]
are assembled as shown in Fig. 14.
Fig. 14
(4) During reassembly, be very careful not to forget to
install the Felt [71] at the lower portion of the Orbital
Cam [46], as shown in Fig. 15.
(5) Grease
Insert 20 g of Nippeco SEP-3A Grease inside the
Gear Cover. Also liberally apply grease to the following
portions:
• the teeth of the Gear [47]
• the slide contact portions of the Balance Weights [45]
• inside of the Needle Bearing [42]
• inside of the Connector [39]
• the slide contact portions of the Plunger [58A]
• the Plunger Holder Ass'y [35] surfaces in sliding
contact with the Connector [39]
Fig. 15
Orbital Cam [46]
Washer (A) [44]
Gear [47]
Spindle [49]
Weight Holder [43]
Washer (A) [44]
Balance Weights [45]
Orbital Cam [46]
Orbital Pin [70]
Felt [71]
Gear Cover
[51]
